Mechanical equipment design

Introduction
• Design Calculations for Static Equipments (Manual Calculation Concept + S/w Practice)
• Preparation of G.A. Drawings and Fabrication Drawings of Equipments
• Vendor Print (Fabrication Drawing) Checking & Approval
• Criteria for Material Selection
• Basic Information about Quality Assurance, Inspection & Testing

Pressure Vessel / Column / Reactor Design Calculation (ASME SEC VIII, DIV. 1)
• Maximum Allowable Stress Values (UG-23)
• Shell Design for Internal Pressure (UG-16, UG-27, Appendix 1-2)
• Dished End Design For Internal Pressure (UG-32)
• Shell Design for External Pressure (UG- 28, UG-29, UG-30)
• Dished End Design For External Pressure (UG-33)
• Hydro test Pressure / Pneumatic Test (UG-99, UG-100)
• Wind Load (IS- 875, Pt-3)
• Seismic Load (IS- 1893, Pt-1&4)
• Combined Loading Effect
• Conical & Tri conical Section Analysis (UG-32, 33, Appendix 1-5 & 1-8)
• Weight Calculation
• Opening (Nozzles) (UG-36, UG-45 & Appendix 1-7)
• Local Load (WRC 107 & 297)
• MDMT & Impact Test Enigma (UCS-66)
• Lifting & Tailing Lug Analysis
• Support Analysis (Skirt, Leg, Saddle)
• PWHT (UCS-56)
• Joint Efficiency, MAWP, MAP, SR of DE for Forming Operation

Heat Exchanger
• Heat Exchanger Types, Classification, categories and Nomenclatures as per TEMA
• Geometrical Configuration as per TEMA & EIL Stds / Good Engg. Practice
• Thermal Design know how
• Mechanical Design as Per TEMA & UHX (ASME)

Storage Tanks
• Design of Tank Components as per Codes & Standards, Bottom Plate Layout & Testing
• Shell Design by One Foot Method, Conical Roof & Dome Roofs, Basic Consideration in Design of Floating Roofs, Design for Wind Girders/Stiffness, Nozzles and Accessories
• Inspection & Testing

Comments are closed.